ROTFIX

ROTFIX is a two-part penetrating epoxy wood hardener. It waterproofs and reinforces wood after it penetrates and hardens. It is 100% active ingredient with no fillers or thinners. It is part of the Total Wood Restoration System for regenerating rotted windows, doors, boats and ships, beams, posts, logs and columns. It also reinforces, waterproofs and hardens wood. ROTFIX is to be used after the rot has been removed and the remaining wood treated with borate based wood preservative.

Application: Apply to affected area with mixing/applicator squeeze bottle, syringe, brush or roller. The wood must be dry. Repeat if necessary. You cannot use too much. Make sure all surfaces are coated. No thinning is necessary. However, in cooler temperatures and to increase penetration with reduced viscosity, it can be thinned with acetone.

Technique: An easy method is to apply the ROTFIX from the mixing bottle and brush it out with a small paintbrush. Make small batches, just a few ounces at a time. Make sure all surfaces being repaired get coated with at least one heavy coat. Have a small container of sand nearby and pour any unused ROTFIX into the sand to avoid curing in the bottle. Warm weather TIP: When temperatures outside are above 80 degrees, keep the A and B components in an ice chest. Otherwise, when components are hot, they can react and harden in 5 minutes or less - before you have a chance to use them. Heat accelerates the curing process. Cold Weather TIP: When it is cold outside, cure times can take many times longer. Warm the components to room temperature or keep them in an inside pocket of your coat to accelerate cure times. TIP: Use a hair dryer or heat gun to warm the bare wood prior to application and then keep the repair warm for several minutes after application.

Clean-up: Uncured mixed ROTFIX (Part A and Part B) may be cleaned up with white vinegar or acetone, then flushed with water.

Safety: ALWAYS WEAR PROTECTIVE DISPOSABLE GLOVES WHEN USING THIS PRODUCT. Avoid skin contact. Skin sensitization may result from prolonged and repeated contact. If use causes soreness, redness, blistering, or other symptoms of irritation, stop use and see a physician immediately. Use with adequate ventilation. If eye contact occurs, flush with large quantities of water and contact physician immediately. Do not use around open flame. If Part A is swallowed, induce vomiting. If Part B is swallowed, DO NOT INDUCE VOMITING. Keep out of reach of children.