SCULPWOOD
SCULPWOOD
will not crack, split or shrink. This versatile product will rebuild and restore
wood's integrity and form a permanent bond to most rigid surfaces. Porous surfaces
like wood should first be coated with ROTFIX.
Application:
With disposable gloves on each hand, knead together one part of SCULPWOOD Part
A with one Part B by volume. Mix no more than can be applied within 15 minutes.
Start with a golf ball size of Part A and a golf ball size of B. They are different
colors, so knead them together for at least 1 full minute - or until the mix is
one completely uniform color. Insufficient blends give poor results.
Technique: When cured, SCULPWOOD can be sawed, nailed, carved, machined,
and sanded. SCULPWOOD can also be stained or painted. (If stained, you will need
to experiment with various colors as it does not accept stain color the same as
the adjacent wood.) TIP: When it is warmer than 80 degrees outside, flatten out
the mixed ball of Part A and B into a pancake. If left in a ball, heat will build
up and it will begin to cure in the middle. TIP: Use a putty knife dipped in acetone
or white vinegar to smooth the rough shape. Always leave slightly more material
in the void than you need to fill it. In about 24 hours, it is simple to sand
flush to the original surface. If you sand too much, or under fill the void, the
surface will have to be wetted with ROTFIX before additional SCULPWOOD
can be added. You can also mix ROTFIX and SCULPWOOD to achieve a more desired
consistency.
|
|
Recommended
Usage:
It
is part of the Total Wood Restoration System for regenerating rotted windows,
doors, boats and ships, beams, posts, logs and columns. It also reinforces, waterproofs
and hardens wood. ROTFIX is to be used after the rot has been removed and
the remaining wood treated with borate based wood preservative. |
Clean-up:
Uncured Mixed SCULPWOOD (Part A and Part B) may be cleaned up with white vinegar
or acetone, and then flushed with water.
Safety: ALWAYS
WEAR PROTECTIVE DISPOSABLE GLOVES WHEN USING THIS PRODUCT. Avoid skin contact.
Skin sensitization may result from prolonged and repeated contact. If use causes
soreness, redness, blistering, or other symptoms of irritation, stop use and see
a physician immediately. Use with adequate ventilation. If eye contact occurs,
flush with large quantities of water and contact a physician immediately. Do not
use around open flame. If Part A is swallowed, induce vomiting. If Part B is swallowed,
DO NOT INDUCE VOMITING. Keep out of reach of children.
Use SCULPWOOD to replace
missing sections of window sills, frames, furniture, columns, logs or any wood
structure. Use it to add new sections to already completed structures.
|
